Digi ConnectPort TS 8 MEI Quick Start Manual

Download Quick start manual of Digi ConnectPort TS 8 MEI Network Hardware, Server for Free or View it Online on All-Guides.com.

Digi ConnectPort TS 8 MEI Quick start manual - Page 1
1
Digi ConnectPort TS 8 MEI Quick start manual - Page 2
2
Quick Start
Guide
ConnectPort® TS 8, TS 8 MEI,
TS 16, TS 16 MEI
1 Verify your components
Verify that you have all included equipment.
If any item is missing or damaged, contact your supplier.
Included equipment
2 Connect the hardware
Pin positions for connecting serial devices
10-wire jack (female) 10-wire connector (male) 8-wire connector (male)
ConnectPort TS
products use an RJ-45
10-wire jack (female),
with Pin 1 in the
following location:
For a 10-wire connector, Pin 1 of
the connector is in the following
location:
For an 8-wire connector, connect the
pins to the center 8 pins of the 10-wire
jack:
Pin # on
10-wire
connector
Pin # on
8-wire
connector EIA-232
MEI products only
PortServer TS 8/16 MEI
only
EIA-422/485
full-duplex
EIA-485 half-
duplex
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
RI
DSR*
RTS
CGND
TxD
RxD
SGND
CTS
DTR
DCD*
TxD-
RxD-
RTS+
CGND
TxD+
RxD+
SGND
CTS+
RTS-
CTS-
N/A
DATA-
N/A
CGND
N/A
DATA+
SGND
N/A
N/A
N/A
N/A
RxD-
TxD+
CGND
No connection
RxD+
SGND
No connection
TxD-
N/A
*Use the Altpin setting to swap these two signals.
© 2016 Digi International Inc.
Digi, Digi International, and the Digi logo are trademarks or registered trademarks in the United States and other countries worldwide. All other trademarks mentioned in this document are the
property of their respective owners.