Edge-Core SAF51003I Quick Start Manual
Download Quick start manual of Edge-Core SAF51003I Network Hardware for Free or View it Online on All-Guides.com.
Brand: Edge-Core
Category: Network Hardware
Type: Quick start manual for Edge-Core SAF51003I
Pages: 4
1
2
3
4
– 1 –
Desktop Mount the Device
1. Attach the four rubber foot pads to the base of the device, and
then place it on a desktop or shelf.
Ground the Device
1. Ensure the device is properly grounded in compliance with ETSI
ETS 300 253. Verify that there is a good electrical connection to
the grounding point (no paint or isolating surface treatment).
2. Attach the grounding wire (#14 AWG) to the grounding point
on the device rear panel. Then connect the other end of the wire
to ground.
Connect Power
1. Connect the AC/DC power adapter to the DC jack on the
device.
2. Connect the AC/DC power adapter to an external AC power
source.
Verify Device is Powered On
1. Verify the device is powered on by checking the PWR LED.
When operating normally, the PWR LED should be on green.
Connect Network Cables
1. For the RJ-45 ports, connect 100-ohm Category 5, 5e or better
twisted-pair cable.
Note:
The device is an open platform with Ubuntu Linux
pre-installed, but no application software.
1
1
2
1
2
3
1
2
4
1
5
1
E082018-AP-R01
150200001998A
Network Security Platform
SAF51003I
1.
Network Security Platform SAF51003I
2. Four adhesive foot pads
3. AC/DC Power Adapter
4. Power Cord—either Japan, US, Continental Europe or UK
5. Console Cable—RJ-45 to DB-9
1
Package Contents
4
5
2
3
Quick Start Guide