Juniper SRX4100 How To Set Up

Download How to set up of Juniper SRX4100 Gateway for Free or View it Online on All-Guides.com.

Brand: Juniper

Category: Gateway

Type: How to set up for Juniper SRX4100

Pages: 6

Download Juniper SRX4100 How to set up

Juniper SRX4100 How to set up - Page 1
1
Juniper SRX4100 How to set up - Page 2
2
Juniper SRX4100 How to set up - Page 3
3
Juniper SRX4100 How to set up - Page 4
4
Juniper SRX4100 How to set up - Page 5
5
Juniper SRX4100 How to set up - Page 6
6
How to Set Up Your SRX4100 Services Gateway
5
Configure Root Authentication
Before you can use J-Web to configure your device, you must access the CLI to
configure root authentication.
1. Log in to the device as root. When the device is powered on with the factory-
default configuration, you do not need to enter a password.
2. At the (%) prompt, type cli to start the CLI and press Enter. The prompt
changes to an angle bracket (>) when you enter the CLI operational mode.
root%cli
root>
3. At the (>) prompt, type configure and press Enter. The prompt changes from
> to # when you enter configuration mode.
root> congure
Entering conguration mode
[edit]
root#
4. Set the root authentication password by entering a cleartext password, an
encrypted password, or an SSH public key string (DSA or RSA).
root# set system root-authentication plain-text-
password
New password: password
Retype new password: password
5. Configure the route for the management interface (optional, required only if
you do not connect the MGMT port directly to the management device).
root# set routing-options static route <destination
prex> next-hop <gateway>
6. Commit the configuration changes.
root# commit
7. Connect the MGMT port on the device to the Ethernet port on the
management device using an RJ-45 cable.
8. Configure an IP address on the 192.168.1.0/24 subnetwork for the
management device. By default, the management interface is configured with
the 192.168.1.1/24 IP address. If you need to change the IP address, perform
the following steps or else proceed to Step 9.
a. Delete the default management interface IP address.
root# delete interface fxp0 unit 0 family inet
address 192.168.1.1/24
b. Configure a new IP address for the management interface.
root# set interfaces fxp0 unit 0 family inet address
address/prex-length
c. Commit the configuration changes.
root# commit
d. Configure an IP address for the management device. Ensure that the IP
address is on the same subnetwork as the management interface (fxp0).
9. Launch a Web browser from the management device and access the services
gateway using the URL https://192.168.1.1.
If you changed the management interface IP address in Step 8, then use the
URL https://<management IP address> to access the services gateway.
NOTE: As the system-generated certificate is not trusted by default, an
alert is displayed. You can ignore this alert and proceed to access the
services gateway.
The J-Web login page is displayed. This indicates that you have successfully
completed the initial configuration and that your SRX4100 Services Gateway
is ready for use.