Ramsey Electronics RR1 Instruction Manual

Download Instruction manual of Ramsey Electronics RR1 Remote Control for Free or View it Online on All-Guides.com.

Ramsey Electronics RR1 Instruction manual - Page 1
1
Ramsey Electronics RR1 Instruction manual - Page 2
2
Ramsey Electronics RR1 Instruction manual - Page 3
3
Ramsey Electronics RR1 Instruction manual - Page 4
4
Ramsey Electronics RR1 Instruction manual - Page 5
5
Ramsey Electronics RR1 Instruction manual - Page 6
6
Ramsey Electronics RR1 Instruction manual - Page 7
7
Ramsey Electronics RR1 Instruction manual - Page 8
8
Ramsey Electronics RR1 Instruction manual - Page 9
9
Ramsey Electronics RR1 Instruction manual - Page 10
10
Ramsey Electronics RR1 Instruction manual - Page 11
11
Ramsey Electronics RR1 Instruction manual - Page 12
12
Ramsey Electronics RR1 Instruction manual - Page 13
13
Ramsey Electronics RR1 Instruction manual - Page 14
14
Ramsey Electronics RR1 Instruction manual - Page 15
15
Ramsey Electronics RR1 Instruction manual - Page 16
16
Ramsey Electronics RR1 Instruction manual - Page 17
17
Ramsey Electronics RR1 Instruction manual - Page 18
18
Ramsey Electronics RR1 Instruction manual - Page 19
19
Ramsey Electronics RR1 Instruction manual - Page 20
20
Ramsey Electronics Model No. RR1
Have you ever been so frustrated with the range of your remote
that you go to the extreme of rearranging your entertainment
room just to make it work? Tired of having to bounce your IR
remote off of ceilings and walls? Do you want to run your
system from another room? Here is the answer to your prayers!
Extend the range of your remote controls as far as you need;
it’s only limited by the length of wire you use!
IR receiver module with sensitive element can receive your
remote control up to 36 feet away before re-broadcasting it.
The RR1 reconstitutes the receive signal using a PIC micro
controller, restores noisy or weak signals, and then re-broadcasts
the IR remote signals to your components via a long wire (tested
over 500 feet!) to a high-efficiency IR LED.
Extend the range of your remote control around corners or down
floors by running a wire to an IR LED in front of the components
you wish to control.
Works with almost any remote control (38 kHz carrier), does not
need to be programmed.
Will operate from 8V to 16V AC or DC. Use our AC125 wall adapter
for long operation.
LED indicator lets you know when you are receiving an IR signal
or not.