LEGRAND RFB9 Installation Instructions Manual

Download Installation instructions manual of LEGRAND RFB11 Kitchen Appliances for Free or View it Online on All-Guides.com. This version of LEGRAND RFB11 Manual compatible with such list of devices, as: RFB11, RFB119, RFB119BTC, RFB119CTC, RFB9

LEGRAND RFB11 Installation instructions manual - Page 1
1
LEGRAND RFB11 Installation instructions manual - Page 2
2
LEGRAND RFB11 Installation instructions manual - Page 3
3
LEGRAND RFB11 Installation instructions manual - Page 4
4
LEGRAND RFB11 Installation instructions manual - Page 5
5
LEGRAND RFB11 Installation instructions manual - Page 6
6
LEGRAND RFB11 Installation instructions manual - Page 7
7
LEGRAND RFB11 Installation instructions manual - Page 8
8
RFB 119 Series Floor Box
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 1 003 189R1 Updated April 2011
Products Covered: Floor Box Cat. Nos.: RFB9, RFB11,
Floor Box Covers: RFB119CTC, RFB119BTC
Floor Box Device Plates: RFB119 (suffix)
CAUTION: Do not operate tile stripper or resurfacing equipment over top of covers. This may result in damage to the surface finish
of the product.
CAUTION: When used in bare concrete or terrazzo floors, use part number: RFB119-PAN (Sold separately).
CAUTION: Box has no post pour adjustment.
Step 1 Locate and position box in accordance to floor
plans or blueprint.
6 5/16"
[161mm]
7
"
[
178mm]
14"
[356mm]
12 5/8"
[321mm]
Step 2 Level & anchor box. Top of box must be flush with
concrete pour. Use screws, nails, or wire to prevent
box from floating during pour.
Step 3 Remove mudcap and attach conduit.
Step 4 Reinstall mudcap.
Legrand/Wiremold electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Legrand/Wiremold electrical
products may bear the mark of a Nationally Recognized Testing
Laboratory (NRTL) and should be installed in conformance with current
local and/or the National Electrical Code.
IMPORTANT: Please read all instructions
before beginning.
NOTE: For use in bare concrete or terrazzo floors, replace
mudcap with part number: RFB119-PAN. (Sold
separately.) (See Step 19.)