Juniper EX9214 Hardware Manual
Download Hardware manual of Juniper EX9214 Network Router, Switch for Free or View it Online on All-Guides.com.
Brand: Juniper
Category: Network Router , Switch
Type: Hardware manual for Juniper EX9214
Pages: 372
The Gigabit Ethernet SFP, SFP+, and QSFP+ transceivers installed in EX4300 switches
support digital optical monitoring (DOM): You can view the diagnostic details for these
transceivers by issuing the operational mode CLI command show interfaces diagnostics
optics.
NOTE: The transceivers support DOM even if they are installed in the SFP+
uplink module ports or QSFP+ ports configured as Virtual Chassis ports
(VCPs).
•
EX4500—Uplink module ports on EX4500 switchessupport SFP and SFP+ transceivers.
You can find the list of transceivers supported on EX4500 switches and information
about those transceivers at the Hardware Compatibility Tool page for EX4500.
The Gigabit Ethernet SFP and SFP+ transceivers installed in EX4500 switches support
digital optical monitoring (DOM): You can view the diagnostic details for these
transceivers by issuing the operational mode CLI command show interfaces diagnostics
optics.
NOTE: The transceivers support DOM even if they are installed in uplink
module ports configured as Virtual Chassis ports.
•
EX4550—Uplink module ports on EX4550 switches support SFP, SFP+, and QSFP+
transceivers. You can find the list of transceivers supported on EX4550 switches and
information about those transceivers at the Hardware Compatibility Tool page for
EX4550.
The SFP, SFP+, and QSFP+ transceivers installed in EX4550 switches support digital
optical monitoring (DOM): You can view the diagnostic details for these transceivers
by issuing the operational mode CLI command show interfaces diagnostics optics.
NOTE: The transceivers support DOM even if they are installed in the
expansion module ports or SFP+ network ports configured as Virtual
Chassis ports (VCPs).
•
EX4600—The quad small form-factor pluggable plus (QSFP+) ports in EX4600
switches support QSFP+ transceivers, QSFP+ direct-attach copper (DAC) cables, and
DAC breakout cables (DACBO). Each QSFP+ port on an EX4600 switch can be
configured to operate as 10-Gigabit Ethernet interface by using a breakout cable or as
a single 40-Gigabit Ethernet interface. The ports on an EX4600 switch are disabled
by default. You enable a port through the CLI. The 24 downlink or access ports of the
EX4600 switch are 10-Gigabit Ethernet. You can find the list of transceivers supported
on EX4600 switches and information about those transceivers at the Hardware
Compatibility Tool page for EX4600.
•
EX6200—Uplink ports on the Switch Fabric and Routing Engine (SRE) module and
line cards in EX6200 switches support SFP and SFP+ transceivers. You can find the
109Copyright © 2017, Juniper Networks, Inc.
Chapter 8: Transceiver and Cable Specifications