Juniper EX9214 Hardware Manual
Download Hardware manual of Juniper EX9214 Network Router, Switch for Free or View it Online on All-Guides.com.
Brand: Juniper
Category: Network Router , Switch
Type: Hardware manual for Juniper EX9214
Pages: 372
Before you install a DC power supply in the switch:
•
Ensure you understand how to prevent Electrostatic discharge (ESD) damage. See
“Prevention of Electrostatic Discharge Damage” on page 329.
•
Ensure that the voltage across the DC power source cable leads is 0 V and that there
is no chance that the cable leads might become active during installation.
Ensure that you have the following parts and tools available:
•
ESD grounding strap
•
Phillips (+) screwdriver, number 1
To install a DC power supply in an EX9214 switch:
1. Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
point on the chassis.
2. If the power supply slot has a cover panel on it, unscrew the screw on the side of the
cover panel in the counterclockwise direction using the Phillips (+) screwdriver,
number 1, and remove the cover panel. Save the cover panel for later use.
3. Taking care not to touch power supply components, pins, leads, or solder connections,
remove the power supply from its bag.
4. Move the DC circuit breaker on the power supply faceplate to the Off (O) position.
5. Check whether the release lever below the empty power supply slot is locked in the
counterclockwise direction (see Figure 65 on page195). If it is not, pull the spring-loaded
locking pin in the release lever away from the chassis and turn the release lever in the
counterclockwise direction until it stops, and then let go of the locking pin in the release
lever, and ensure that it is seated in the corresponding hole in the chassis.
6. Using both hands, slide the power supply straight into the chassis until the power
supply is fully seated in the slot on the rear of the switch. The small tab on the metal
housing that is controlled by the release lever must be inside of the corresponding
slot at the bottom of the power supply (see Figure 65 on page 195). Ensure that the
power supply faceplate is flush with any adjacent power supply faceplates or power
supply cover panels.
Copyright © 2017, Juniper Networks, Inc.194
EX9214 Switch Hardware Guide