Juniper EX9214 Hardware Manual
Download Hardware manual of Juniper EX9214 Network Router, Switch for Free or View it Online on All-Guides.com.
Brand: Juniper
Category: Network Router , Switch
Type: Hardware manual for Juniper EX9214
Pages: 372
Ensure that you have the following parts and tools available:
•
(If you will install only one EX9200-10XS-MIC or EX9200-20F-MIC) A septum and
screws to secure the septum
•
(If you will install only one EX9200-10XS-MIC or EX9200-20F-MIC) A cover panel and
screws to secure the cover panel
•
Rubber safety caps to cover transceivers
•
ESD grounding strap
•
Phillips (+) screwdriver, number 2
To install a MIC in an EX9200-MPC line card:
1. Attach the ESD grounding strap to your bare wrist and connect the strap to the ESD
point on the rear panel of EX9200 switches.
2. If the MIC slot on the line card has a cover panel on it, use the screwdriver to remove
the captive screws on each side of the cover panel. Save the cover panel and the
screws for later use.
NOTE: If you are installing only one MIC, ensure that the empty MIC slot
is covered by a cover panel.
3. If you will install only one EX9200-10XS-MIC or EX9200-20F-MIC and if there is no
septum installed in the line card, install the septum (see Figure 77 on page 227):
a. Position the septum in the center of the MIC slot on the line card so that it is aligned
with the holes labeled S on the top and bottom surfaces of the line card.
b. Insert a screw each into the holes labeled S on the top surface of the line card and
tighten the screws by using the screwdriver.
c. Insert a screw each into the holes labeled S on the bottom surface of the line card
and tighten the screws by using the screwdriver.
Copyright © 2017, Juniper Networks, Inc.226
EX9214 Switch Hardware Guide