Certance LTO 1 Install Manual

Download Install manual of Certance LTO-1 Storage for Free or View it Online on All-Guides.com.

Brand: Certance

Category: Storage

Type: Install manual

Model: Certance LTO-1 , Certance LTO-2 , Certance Tape Drive LTO-3

Pages: 8 (1.02 Mb)

Download Certance LTO-1 Install manual

Certance LTO-1 Install manual - Page 1
1
Certance LTO-1 Install manual - Page 2
2
Certance LTO-1 Install manual - Page 3
3
Certance LTO-1 Install manual - Page 4
4
Certance LTO-1 Install manual - Page 5
5
Certance LTO-1 Install manual - Page 6
6
Certance LTO-1 Install manual - Page 7
7
Certance LTO-1 Install manual - Page 8
8
This document provides instructions for manually removing a data cartridge from a Certance LTO-1, LTO-2,
or LTO-3 full-height tape drive. You should only perform this procedure if you cannot remove the cartridge
by pushing the buttons on the front of the drive or by issuing commands from a host device. This should
only be necessary if you must remove a data cartridge prior to returning the drive to Certance.
CAUTION: After following these procedures, you must return the drive to Certance for repair. Do not
try to use the drive until after it has been serviced.
Before You Start
Before you manually remove a cartridge from the drive:
1. Issue all possible commands and run diagnostics.
2. Turn off all power to the drive.
3. Unplug all connectors to the drive.
4. Remove the drive from its operating environment.
5. Place the drive on a workbench with proper ESD grounding: attach a wrist strap to the bench
and the other end to your wrist.
6. Remove the top cover of the drive by removing eight screws. (You will need a 1.5-mm hex
driver.)
NOTE: Do NOT remove the front bezel or the bottom cover from the drive.
7. Inspect the drive to determine which procedure you should follow:
If the cartridge is loaded and the leader pin is still in the cartridge (see Figure 1), go to “Cartridge
is Loaded and Seated” on page 2.
If the cartridge is loaded and seated, and the tape is threaded or partially threaded on the take-up
hub, go to “Cartridge is Loaded and Seated with Tape Threaded” on page 4.
Manually Removing an LTO Cartridge