Vicon VM615 Instructions For Installation And Operation Manual

Download Instructions for installation and operation manual of Vicon VM615 Monitor for Free or View it Online on All-Guides.com.

Brand: Vicon

Category: Monitor

Type: Instructions for installation and operation manual for Vicon VM615

Pages: 8

Download Vicon VM615 Instructions for installation and operation manual

Vicon VM615 Instructions for installation and operation manual - Page 1
1
Vicon VM615 Instructions for installation and operation manual - Page 2
2
Vicon VM615 Instructions for installation and operation manual - Page 3
3
Vicon VM615 Instructions for installation and operation manual - Page 4
4
Vicon VM615 Instructions for installation and operation manual - Page 5
5
Vicon VM615 Instructions for installation and operation manual - Page 6
6
Vicon VM615 Instructions for installation and operation manual - Page 7
7
Vicon VM615 Instructions for installation and operation manual - Page 8
8
VICON
7c
INSTRUCTIONS FOR
INSTALLATION AND OPERATION
MODEL
VM615’154NCH
HIGH-RESOLUTION COLOR MONITOR
1. INTRODUCTION
This manual provides installation and operation proce-
brightness, contrast,
chroma
(color saturation), phase
dures for the VM615 15-Inch High-Resolution Color
(tint), vertical and horizontal hold, vertical and horizon-
Monitor. The monitor is available in two model variations:
tal position, and vertical size. Refer to Figure 1.
VM615, designed for use with the EIA/NTSC
television system and a 120
V,
60 Hz power
source.
VM615-P, designed for the CCIR/PAL
television system and for a 230 V, 50 Hz
power source.
Both models will be referred to as the VM615 in this
manual, unless specified otherwise.
This monitor should only be installed by qualified per-
sonnel using approved materials and practices in con-
formance with federal, state, and local codes. Read these
instructions thoroughly before beginning an installation.
Failure to comply with these instructions may result in
personal injury and/or damage to the equipment.
Standard connectors are provided for all signal inputs:
BNC connectors for composite video, miniature four-
pin DIN connector for S-VHS video, and RCA connec-
tors for audio. The monitor is housed in a steel cabinet
with generous provision for air circulation to dissipate
heat. The cabinet is provided with a carrying handle. A
detachable power cord that plugs into a standard IEC
320 power cord connector is supplied. The fuse is housed
in a fuse tray built into the IEC 320 connector for easy
access without having to remove the monitor case.
A looping output connector (BNC) is provided for com-
posite video, along with a switch for selecting 75-ohm
or high-impedance video termination. A looping output
connector (RCA) is also provided for audio.
The VM615 is intended for use in closed-circuit televi-
sion (CCTV) systems. Horizontal resolution is an ex-
tremely high 600 TV lines. Inputs are provided for
standard composite video (NTSC RS-170A or CUR/PAL,
depending on monitor model) and for separate Y/C signals
for playback of S-VHS tapes. Composite or S-VI-IS input
channels are selected with front-panel pushbuttons. The
monitor also features a built-in speaker. Controls include
The VM615 meets FCC requirements for a Class A
device. The
VM615-P
complies with European Com-
munity EMC Directive
89/336.
The product was sub-
jected to the testing outlined in European Normalization
Standard EN 50081-l (Electromagnetic Compatibility
-
General Emissions Standard Part 1: Residential, Com-
mercial, and Light Industry), and EN 50082-l (Electro-
magnetic Compatibility
-
Generic Immunity Standard
Part 1: Residential, Commercial, and Light Industry).
2. INSTALLATION
This monitor should only be installed by qualified
per-
sonnel using approved materials and practices in
con-
formance with federal, state, and local codes.
CAUTION:
All monitors must be installed in a
A
location that provides adequate air circulation
for cooling. Do not blockany of the air circulation
openings in the cabinet.
WARNING: TO PREVENT RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
Product specifications subject to change without notice.
(CEI
Vicon part number 8006-8916-00-00
Copyright
0
1997 Vicon Industries Inc. All rights reserved.
Vicon and its logo are registered trademarks of Vicon Industries Inc.
VICON INDUSTRIES INC. 89 ARKAY DRIVE, HAUPPAUGE, N.Y. 11788 l TEL:
.516-952~CC-W
l FAX: 516-951XCTV
TOLL FREE: l-800-645-91 16 l UK:
44/(O)
1489/577775
. INFOFAX: 1-800-287-i 207