Yakima Landing Pad 7 Instructions Manual

Download Instructions manual of Yakima Landing Pad 7 Automobile Accessories for Free or View it Online on All-Guides.com.

Yakima Landing Pad 7 Instructions manual - Page 1
1
Yakima Landing Pad 7 Instructions manual - Page 2
2
Yakima Landing Pad 7 Instructions manual - Page 3
3
Yakima Landing Pad 7 Instructions manual - Page 4
4
Yakima Landing Pad 7 Instructions manual - Page 5
5
Yakima Landing Pad 7 Instructions manual - Page 6
6
Yakima Landing Pad 7 Instructions manual - Page 7
7
Yakima Landing Pad 7 Instructions manual - Page 8
8
Yakima Landing Pad 7 Instructions manual - Page 9
9
Yakima Landing Pad 7 Instructions manual - Page 10
10
Yakima Landing Pad 7 Instructions manual - Page 11
11
Yakima Landing Pad 7 Instructions manual - Page 12
12
Landing Pad #5
1033034B-1/12
Landing Pad #7
Part #1033034 Rev.B
IMPORTANT WARNING!
IT IS CRITICAL THAT ALL YAKIMA
RACKS AND ACCESSORIES BE
PROPERLY AND SECURELY
ATTACHED TO YOUR VEHICLE.
IMPROPER ATTACHMENT COULD
RESULT IN AN AUTOMOBILE
ACCIDENT, AND COULD CAUSE
SERIOUS BODILY INJURY OR
DEATH TO YOU OR TO OTHERS.
YOU ARE RESPONSIBLE FOR
SECURING THE RACKS AND
ACCESSORIES TO YOUR CAR,
CHECKING THE ATTACHMENTS
PRIOR TO USE, AND
PERIODICALLY INSPECTING THE
PRODUCTS FOR ADJUSTMENT,
WEAR, AND DAMAGE.
THEREFORE, YOU MUST READ
AND UNDERSTAND ALL OF THE
INSTRUCTIONS AND CAUTIONS
SUPPLIED WITH YOUR YAKIMA
PRODUCT PRIOR TO
INSTALLATION OR USE. IF YOU DO
NOT UNDERSTAND ALL OF THE
INSTRUCTIONS AND CAUTIONS,
OR IF YOU HAVE NO
MECHANICAL EXPERIENCE AND
ARE NOT THOROUGHLY FAMILIAR
WITH THE INSTALLATION
PROCEDURES, YOU SHOULD
HAVE THE PRODUCT INSTALLED
BY A PROFESSIONAL INSTALLER
SUCH AS A QUALIFIED GARAGE
OR AUTO BODY SHOP.
TO BEGIN, ASSEMBLE THE CONTROL TOWERS ONTO THE CROSSBARS:
Slide two towers onto each crossbar. Do
not tighten.
Be careful to keep the bars horizontal; the
loose towers could slide from the bar and fall.
Using the wrench
provided in Control Tower
carton, loosen towers.
Open Control Towers
RECOMMENDED TOOLS:
Tape measure, #2 pencil, drill, drill bits from 1/8” to 25/64”, drill stop or masking tape, punch, touch-up paint and eye protection.
Weight & load
limits are
determined by
the customer/
installer and will
vary depending
upon the
placement of the
Landing Pads
and the strength
& construction of
the material
they are
attached to.
Maximum
weight